#51983 - 02/14/10 05:42 PM
What ya workin on?
|
Full Throttle Member
Registered: 07/31/01
Posts: 4789
Loc: Pennsylvania
|
Can anyone tell I got cabin fever Today, I removed twin cone air intake. Cleaned, oiled and replaced with a Blackwing. Charged battery Got my spare tps out for inspection and get ready to install on my new rims that should be here tomorrow Hunted down my new chrome lug nuts that look much better than the oem. Got my new hoses out for replacement. Whats next? Paint the rotor hats and inside the vanes to prevent rust. Remove torn A pillar weatherstrip and replace. Get ready to remove my BSM and total detail of the car. Get state inspection and install my new brakes Mount new tires on new rims Lower the car a little bit. Get alignment 4 wheel done Flush brake fluid and power steering fluid coolant, too. Price out and locate vendor for window tint. More chrome do dads 
_________________________
SOLD MY C5 Looking for my next one
|
|
Top
|
|
|
|
#51985 - 02/14/10 06:02 PM
Re: What ya workin on?
|
Full Throttle Member
Registered: 07/31/01
Posts: 4789
Loc: Pennsylvania
|
Hey Chewy how ya doin? Ya you can tint but only certain % I don't even know how much. Just lookin for an experienced installer and not so dark that I cant see at night. Got tint?
_________________________
SOLD MY C5 Looking for my next one
|
|
Top
|
|
|
|
#51986 - 02/14/10 08:23 PM
Re: What ya workin on?
|
Full Throttle Member
Registered: 01/01/10
Posts: 106
Loc: Guin, Alabama
|
Just purchased a Porta-cable 7424XP with alot of pads and cleaning products. Just can not make up my mind on new wheels yet  too many to pick from. 
_________________________
Roll Tide Roll 1999 White Convertible Magnaflow cat back exhaust K&N Cold Air Intake system Front hood seal
|
|
Top
|
|
|
|
#51988 - 02/15/10 07:08 AM
Re: What ya workin on?
|
Full Throttle Member
Registered: 12/17/02
Posts: 1928
Loc: Michigan
|
Baseboard moldings in my kitchen! After that, installing an electrical outlet in my basement.
_________________________
1998 Six Speed, Torch Red Coupe - K&N CAI, Vararam Velocity Stack, Z06 exhaust, Z06 sway bars, Z06 intake, C6 Z06 shifter, stainless steel brake lines, Z06 shocks, Borla X pipe, drilled/slotted rotors. Dyno'ed at 330 RWHP & 340 RWTQ.
|
|
Top
|
|
|
|
#51989 - 02/15/10 09:06 AM
Re: What ya workin on?
|
Full Throttle Member
Registered: 08/21/04
Posts: 2527
Loc: Never Never Land
|
My golf swing. Then pretty much the rest of the day thinking of what I can avoid doing tomorrow.
_________________________
Dan
|
|
Top
|
|
|
|
#51990 - 02/15/10 12:40 PM
Re: What ya workin on?
|
Member
Registered: 01/05/10
Posts: 92
Loc: Guntersville, Alabama
|
Well since I am unable to do any physical labor myself (bad shoulder, knee,etc) you get the picture,I have to get someone else to do my mechanic work. Thankfully I have a good friend (Jimmy) who has a repair shop snd is an old hot rodder himself. I say all this so as not to deceive any one into thinking that I am out busting my butt doing anything. I'm sittin' in my recliner.
Jimmy on the other hand is putting a new aluminum B-Cool radiator in my 1987 Camaro. He is also installing a new pull down latch on the rear hatch,re-wiring the tach and the cooling fan, installing a Barry Grant 650 dual line dbl pumper carburetor, reparing the Hurst ratchet shifter, replacing the rear end with a 3.73 Auburn Locker (complete axle).
When he finishes the 87 he's installing the new K&N 57-3035 cold air intake on my 02 C-5 Vert. So as you can see I'm not lazy, I spend a lot of time ordering and delivering parts to Jimmy.
_________________________
2002 Pewter convertible Hankooks,K&N cold air intake. NEXT;short throw shifter,tune up,hard top,wheels
|
|
Top
|
|
|
|
#51991 - 02/15/10 01:26 PM
Re: What ya workin on?
|
Full Throttle Member
Registered: 02/05/07
Posts: 246
Loc: Mandan, ND
|
mweaver: You have got the system down just right. Keep that Jimmy busy and an occasional beer or two also with some kind of good food stuff for both of you. Have great time and Spring will be here before Jimmy gets all those projects finished. 
_________________________
Save the Wave & Keep on Vettin'
Love our 50th. Anniversary Coupe!!
|
|
Top
|
|
|
|
#51992 - 02/15/10 04:20 PM
Re: What ya workin on?
|
Member
Registered: 01/18/07
Posts: 905
Loc: South Florida
|
Ahhh, cabin fever? Not here. I think I'll cruise the Intracoastal today with my top down. Weather is in the low 70's, sunny and warm. One day, I'll head over to the Corvette tuner and have him give me an electronic tune. While I'm waiting for him to finish, I'll be sitting outside, working on my sun tan and smoking a cigar. When he's done, I'll head over to the Waterway Cafe for a cocktail and sit out on the Intracoastal and have some lunch. Did someone say this was February 15th?
_________________________
2001 Corvette Convertible, Navy Blue Metalic, Grey Interior, White Top, Automatic, Z51, Performance Axle Ratio 3:15, Borla X Pipe, Borla Quad 4" Stingers, Blackwing, Tuned and all the bells and whistles.
2003 Ford Thunderbird Convertible, White, Black Hard top, Red/Black Interior
|
|
Top
|
|
|
|
#51994 - 02/15/10 05:21 PM
Re: What ya workin on?
|
Full Throttle Member
Registered: 07/31/01
Posts: 4789
Loc: Pennsylvania
|
Prick I hope that is a nice Cohiba robusto. You will love what a tune does to your car. Yeah 2/15 and only 3 weeks until it will be fit to drive my C5 
_________________________
SOLD MY C5 Looking for my next one
|
|
Top
|
|
|
|
#51995 - 02/15/10 05:24 PM
Re: What ya workin on?
|
Full Throttle Member
Registered: 07/31/01
Posts: 4789
Loc: Pennsylvania
|
C6 is lookin good Can you see out at night? How much$ for the tint? Car is shining bright 
_________________________
SOLD MY C5 Looking for my next one
|
|
Top
|
|
|
|
#51996 - 02/15/10 09:01 PM
Re: What ya workin on?
|
Full Throttle Member
Registered: 07/31/01
Posts: 4789
Loc: Pennsylvania
|
Fired up my C5 today. Stuck in the garage with 3 feet of snow up against the door. The Blackwing is a winner of an improvement. I can feel the improved air flow just from revin the engine. I over oiled the filter for sure but let it sit and dry and removed any excess with paper towels. Thought for sure I'd get a code. Nope just a big grin 
_________________________
SOLD MY C5 Looking for my next one
|
|
Top
|
|
|
|
#51997 - 02/16/10 12:50 PM
Re: What ya workin on?
|
Member
Registered: 11/29/00
Posts: 71
Loc: Raleigh, NC
|
http://www.tintcenter.com/laws/PA/ If you plan to stay legal in PA, with a 70% limit, IMO, I'm not sure I would spend the $$. That's a very light film. The 40% on my truck barely looks tinted to me sometimes. ..
_________________________
Machine Silver / Blk 2008 Z06
|
|
Top
|
|
|
|
|
|