Click here to
show your support
for the NCM
and C5Forum.

Home Discussion Forums Do It Yourself Articles About Your Corvette About This Site

Topic Options
Rate This Topic
#113975 - 07/28/21 09:27 AM Help Pleas I am in trouble.....
Tele Offline
Just Started the Engine

Registered: 07/28/21
Posts: 3
Hello
Pleas if someone can help.
I have a 1999 C5 Corvette that I am replacing the axle seal and left side extended housing seal.I have it all ready to remove but there is a threaded rod about 4 inches long from the transmission to the rear end which has a nut on one end and threaded into the Housing cover.I tried 2 nuts on it to back it out but cannot get it unless I drop the whole rear end.Its the only thing that is stoping me from removing the axle Housing cover.Any Ideas...??

Top
#113976 - 07/28/21 05:40 PM Re: Help Pleas I am in trouble..... [Re: Tele]
Tele Offline
Just Started the Engine

Registered: 07/28/21
Posts: 3
ok...finally found out have to drop the whole rear end ......

Top



Moderator:  BruceF, hcvone, J.B., Shag Finger